Warnings and Installation Checklist
Benchy Sparkling Zero | Important Information
Last updated
Benchy Sparkling Zero | Important Information
Last updated
Warning If the Benchy has just been moved do not turn on unless it has been standing for at least 24 hours. Failure to do so will void warranty. Stand the Benchy in an upright position for at least 24 hours before plugging inot the mains socket.
Warning Ensure there is at least 30mm clearance on each vented side of the Benchy to allow adequate airflow. Not allowing adequate ventilation will void warranty, reduce performance and increase power consumption.
Warning Perform a pressure/leak test prior to use
Warning Do not exceed gas pressure or water pressure stated on the date plate
Warning Only use cold to warm water to clean product lines. Do not use hot water to clean product lines
Let the Benchy Sparkling sit for at least 24 hours after delivery or after sitting on its side before turning the unit on.
Ensure the under-counter cupboard or bench top can support the weight of the Benchy Sparkling when full of water.
Ensure there is adequate ventilation (at least 50mm on each vented side of the Benchy Sparkling) Do not exceed the pressures which are stated on the data plate. Do not set the reservoir temperature to below 2°C
Do not exceed the pressures which are stated on the data plate.
Do not set the reservoir temperature to below 2°C
The Benchy Sparkling is the easiest way to setup a sparkling water system. You can be enjoying chilled sparkling water in under 1 hour with this setup.
