Operation

KL50913 HIZO SPIRO Outdoor Pizza Oven | Operation

Operating Instructions

Using the Oven

1. Make sure the oven has been leak tested and properly positioned according to safety instructions.

2. Remove any remaining packing material.

3. Light the burner using the LIGHTING INSTRUCTIONS below

Connecting the LPG Cylinder

1. To connect the liquid propane gas cylinder:

2. The cylinder valve should be in OFF position.

3. Make sure the burner valve is in OFF position.

4. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage.

5. When connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it stops. Use of a wrench could damage the quick coupling nut and result in a hazardous situation.

6. Open the cylinder valve fully by turning the valve anticlockwise.

7. Before lighting the oven, use a soap and water solution to check all connections for leaks.

8. If a leak is found, turn the cylinder valve OFF, and do not use the oven until local liquid propane dealer can make repairs.

9. Turn the oven burner valve OFF and make sure the oven is cool.

Disconnecting the LPG Cylinder

1. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.

2. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.

3. Place dust cap for cylinder valve outlet whenever the cylinder is not in use

Although the gas connections of the appliance are leak tested prior to packing and shipping, a complete test must be performed at the installation site.

Burner Lighting Instructions

1. Make sure the control knob is in OFF position, and then turn the liquid propane cylinder valve ON by slowly turning counterclockwise.

2. Push in and slowly turn the control knob anticlockwise until you hear a click and the burner ignites.

3. If burner doesn't light, turn the knob OFF, wait 5 minutes and repeat the lighting.

To Light With a Match

1. If burner will not light after several attempts using the control knob, he burner may be lit with a match.

2. If you have already attempted to light the burner using the control knob, wait 5 minutes for any gas to dissipate.

3. Insert a match into the matchstick holder, ignite the match and insert through the oven opening to the burner.

4. Push and turn the control knob to HI slowly, the burner should ignite immediately.

5. If the burner does not light within a few seconds, turn the control knob OFF and wait 5 minutes and try again.

General

• Please always keep the gas bottle in upright position.

• The minimum distance between the equipment and the cylinder is 0.6 m

• The size for 20 lbs LP gas cylinder is 390mm in diameter and 455mm tall

• If the appliance is not in use, the gas must be turned off at the supply cylinder.

• The cylinder used must include a collar to protect the cylinder valve.

• The minimum distance for the appliance and the 20lb gas tank is 600mm apart.

• when changing the gas cylinder which shall be carried out away from any source of ignition

• The absolute necessity of not obstructing the ventilation openings of the cylinder compartment

Gas Regulator

This is a push-on gas fitting. Ensure that the black switch is in the horizontal position. Depress the button located below the black switch and press the regulator on to the tank valve until it locks into place.

This gas fitting is counterclockwise. Make sure that the tank is completely switched off and screw the regulator as far as possible into the gas tank valve.

The pizza stove needs to be placed on a non combustible floor.