Single, Double and Triple Font Kits
KegLand Undercover / Build In / Semi-Integrated Kegerator | Single, Double and Triple Font Kits
Feed this through the gas inlet into the kegerator.
Cut an approximately 1m length of 5mm x 8mm EVABarrier gas line from the end
Cut this section into approx 2 x 50cm lengths
Push each length into the 8mm duotight Equal Tee Piece
Connect the other end of the EVABarrier to the duotight fitting on the coupler or a Ball Lock Disconnect. The fitting will depend on the kegerator setup - whether it is for commercial (brewery made) beer or for homebrew
Insert the remaining length of 5mm x 8mm EVABarrier (that is connected to the regulator) into the the Equal Tee
Triple Font
Feed this through the gas inlet into the kegerator.
Cut an approximately 1.5m length of 5mm x 8mm EVABarrier gas line from the end
Cut this section into approx 3 x 50cm lengths
Push each length into the 8mm duotight Equal Tee Piece
Triple Gas Line Configuration Connect the other end of the EVABarrier to the duotight fitting on the coupler or a Ball Lock Disconnect. The fitting will depend on the kegerator setup - whether it is for commercial (brewery made) beer or for homebrew
Insert the remaining length of 5mm x 8mm EVABarrier (that is connected to the regulator) into the the Equal Tee
Quad Font
Feed this through the gas inlet into the kegerator.
Cut an approximately 2m length of 5mm x 8mm EVABarrier gas line from the end
Cut this section into approx 4 x 50cm lengths
Push each length into the 8mm duotight Equal Tee Piece
Quadruple Gas Line Configuration Connect the other end of the EVABarrier to the duotight fitting on the coupler or a Ball Lock Disconnect. The fitting will depend on the kegerator setup - whether it is for commercial (brewery made) beer or for homebrew
Insert the remaining length of 5mm x 8mm EVABarrier (that is connected to the regulator) into the the Equal Tee
Last updated