Quick Start Guide

Series X User Guide | Quick Start Guide

IMPORTANT SETUP INFORMATION

If kegerator has been moved/delivered do not turn it on unless it has been standing upright for at least 24 hours. Failure to do this will void warranty and may damage the kegerator. Leave the kegerator upright for at least 24 hours before plugging in mains power after receiving and unboxing

Only tip kegerator onto right hand side (as seen from the front), when installing castors etc. Tipping the kegerator towards the inlet side of the compressor will decrease the chance of oil migrating into refrigerant line which can cause cooling and noise issues

CO2 gas can be dangerous. Make sure to always use CO2 in a well ventilated space

Never exceed 40psi in your keg system

Always flush chemicals from the beer line completely before tapping keg

Always check for gas leaks once the kegerator is set up

Ensure there is at least 100mm clearance on each side of the kegerator after installation. Failure to allow adequate clearance will impact cooling performance and void warranty

Inclusions

• 1 x KL07429 MK4 KegLand Regulator or KL30670 MK5 CO2 Regulator - Tool-Free

• 1 x KL00192 Black Plastic Wrap Around Drip Tray

• 1 x KL00222 Set of 4 Castor Wheels + bolts. (2 x Front Locking, 2 Free Spinning)

• 1 x KL00215 CO2 Cylinder Holder (designed to suit 2.6kg gas cylinder)

• 1 x KL00208 Chrome Plated Guard Rail with rubber locking feet

• 1 x KL15783 Wire Shelf (included if you want to convert it back to a can/bottle fridge)

• 1 x KL24051 Carbonation Chart Sticker

IMPORTANT

• After unboxing Series X kegerator, ensure it is left upright and stationary for at least 24 hours before turing on. This allows any oil from the compressor that may have migrated during transit to settle. Failure to do this will void warranty

• It is a good idea to install the castor wheels immediately after unboxing. Once installed, leave the Series X kegerator upright and undisturbed for 24 hours to allow oil etc to settle before plugging into mains power

• Only tip kegerator onto right hand side (as seen from the front), when installing castors. Tipping the kegerator towards the inlet side of the compressor will decrease the chance of oil migrating into refrigerant line which can cause cooling and noise issues

• The Series X.1 Kegerator requires a minimum of 100mm clearance on each side to allow adequate ventilation for heat egress. Failure to allow adequate clearance will impact cooling performance and void warranty.

  Note: When actively cooling, the sides of the kegerator can get quite warm/hot. This is normal and indicates that the kegerator is cooling properly.

Setup

Please refer to this video for a detailed guide to setting up a kegerator.

For detailed, step by step instructions, read on!