search

HIZO One-Shot Instant Read Folding Thermometer Pen

KL48446 HIZO One-Shot Instant Read Folding Thermometer Pen User Guide

hashtag
Features

- Rotating 180° Screen - Backlight - 304 Stainless Steel Folding Thermocouple (Not Thermistor) - Probe Type: Penetration - Temperature Range: -50­°C to 300°C (-58°F to 572°F) - Temperature Accuracy: +/- 0.5°C (0.9°F) - Reading Speed: 2 Seconds - Auto-Off: 3 minutes - Resolution 0.1°C (0.1°F) - Requires 1 x AAA Battery. - Includes small screw driver for battery case

Dimensions: 165mm (Long) 40mm (Wide) x 22mm (Thick)

Thermocouple Probe: 105mm Long

hashtag
Controls

  1. Temperature Display

  2. Lock/Calibration

  3. Backlight

  1. Built In Magnet

  2. Celsius/Fahrenheit Display

  3. Battery Compartment - remove screw to access

hashtag
Functions

  • LOCK: Short press the LOCK button to lock the currently displayed temperature

  • BACKLIGHT: Short press the BACKLIGHT button to illuminate the display. Short press again to turn the backlight off. The backlight will automatically turn off after 10 seconds

  • CELSIUS or FAHRENHEIT Display: Long press the C/F button to switch the temperature diplay from one unnit to the next. This will be saved as the default. To revert to the previous nit, long press C/F again

  • CALIBRATION: Long Press the LOCK button while opening the probe to turn the thermometer on to enter the 100°C Calibration Mode. See Calibration for more detail

hashtag
Operation

  • Open the battery compartment (6) by removing the Phillips head screew with a suitable screwdriver. The thermometer requires 2 x AAA batteries. Ensure correct polarity when installing batteries

  • Open the probe to turn on the thermometer.

  • Closing the probe turns the thermometer off. If left open, the therm,ometer will power off after ~ 10 minutes

  • Insert the tip of the probe where you wish to measure the temperature. The thermometer will display the current temperature

  • Short press the LOCK button to lock the currently displayed temperature if desired

  • Short press the BACKLIGHT button to illuminate the display if desired

hashtag
Calibration

hashtag
100°C Calibration

  1. Bring a pot of water to a boil. Once boiling, turn down to maintain a simmer at 100°C

  2. Hold the LOCK button while opening the probe to enter 100°C Calibration Mode. The screen displays CAL. After CAL flashes for 3 seconds, the current temperature is displayed and flashes.

  3. Insert the probe into the pot of simmering water at 100°C

  4. When the displayed temperature stabilises, press LOCK to save the calibrated temperature value. NOTE: If the measured temperature is not with 96°C-04°C, the screen displays ERR and Calibration cannot be performed

hashtag
Notes

  • Clean the probe after each use to avoid incorrect readings

  • This is a handheld thermometer - do not use in a hot oven

  • If measuring extremely hot food or liquids (over 300°C) do not leave the probe in contact for longer than 60 seconds

  • Warning: The probe will remain hot for a short time after measuring hot food or liquid

  • Do not immerse the body of the thermometer in liquid. The housing is splashproof but not waterproof

PreviousDuotight Female Flare Fittings

Last updated