Series X User Guide | Super Slim Font Kits
Super slim font kits are factory assembled with shanks and beer line already attached
Feed the beer lines from the base of the Super Slim Font into the kegerator
Attach each EVABarrier beer line to a liquid ball lock disconnect or keg coupler
Hand-tighten the tap (sold separately) onto the duotight compatible short shank
Tighten the short shank collar onto the tap using a 7 in 1 tap wrench/spanner
Double check that the the 5mm x 8mm EVABarrier gas line is securely connected to the or regulator
Feed this through the gas inlet into the kegerator. If desired, convert the gas post to a Ball Lock Disconnect fitting using
Cut an approximately 1m length of 5mm x 8mm EVABarrier gas line from the end
Cut this section into approx 2 x 50cm lengths
Double check that the the 5mm x 8mm EVABarrier gas line is securely connected to the or regulator
Feed this through the gas inlet into the kegerator. If desired, convert the gas post to a Ball Lock Disconnect fitting using
Cut an approximately 2m length of 5mm x 8mm EVABarrier gas line from the end
Cut this section into approx 4 x 50cm lengths
Push each length into the 8mm duotight Equal Tee Pieces
Connect the other end of the EVABarrier to the duotight fitting on the coupler or a Ball Lock Disconnect. The fitting will depend on the kegerator setup - whether it is for beer or for
Insert the remaining length of 5mm x 8mm EVABarrier (that is connected to the regulator) into the the Equal Tees
Push each length into the 8mm duotight Equal Tee Pieces
Connect the other end of the EVABarrier to the duotight fitting on the coupler or a Ball Lock Disconnect. The fitting will depend on the kegerator setup - whether it is for beer or for
Insert the remaining length of 5mm x 8mm EVABarrier (that is connected to the regulator) into the the Equal Tees
