Warnings and Installation Checklist

Benchy Carbon | Warnings and Installation Checklist

Warning

Warning If the Benchy has just been moved do not turn on unless it has been standing for at least 24 hours. Failure to do so will void warranty. Stand the Benchy in an upright position for at least 24 hours before plugging inot the mains socket.

Warning Ensure there is at least 100mm clearance on each vented side of the Benchy to allow adequate airflow. Not allowing adequate ventilation will void warranty, reduce performance and increase power consumption.

Warning Perform a pressure/leak test prior to use

Warning Avoid external heat sources such as direct sunlight, gas stoves and other heat generating appliances

Warning Only use KegLand approved cleaners and sanitisers to clean the product lines

Warning Do not set the temperature below 0°C or you risk freezing the beverage you are dispensing

Warning Only use on a flat surface or at a maximum angle of 20° off level

Warning Never use a battery charger, transformer/rectifier, battery eliminator or AC/DC converter to power the unit unless supplied by KegLand

Installation Requirements

Only Use On Flat Surface

The Benchy Carbon should only be used on a flat surface or at a maximum angle of 20 degrees off level. DO NOT operate this unit on its side or at angles greater than 20° or permanent damage to the compressor will occur.

Provide Adequate ventilation & Avoid External External Heat Sources

In order to achieve the best possible performance from the Benchy Carbon we recommend 100mm clearance around air vents. External heat sources such as direct sunlight, gas stoves or other heat generating appliances should be avoided.

Do Not Use Battery Chargers or DC Generators

Never use a battery charger, transformer/rectifier, battery eliminator or AC/DC converter to power the product (unless supplied by KegLand). Such equipment can, under certain circumstances, deliver current at a voltage which may damage the inverter. In order to use these devices always ensure that a battery is connected in parallel between the charging equipment and the product