Operating & Cleaning Benchy Slushy

Benchy Slushy | Using the Benchy Slushy

Before First Use

IMPORTANT: Review all warnings at the beginning of the user manual.

1. Remove all packaging materials from the unit.

2. Wash all parts in warm, soapy water.

3. Thoroughly rinse and air-dry all parts.

4. Wipe control panel, motor base, and evaporator with a soft cloth. Allow to dry completely before using.

5. Place the unit on countertop for at least 2 hours before operating. This allows the refrigerant to settle in the condenser for optimal and safe use.

Operation

1

Turn the Benchy Slushy On

Connect power, two dashes will appear on the display to show it has power. Hold the On/Off button for 3 seconds to turn the unit on. The display will now show C or F depending on the temperature units in use.

2

Add Contents

Add your ingredients through the fill port, DO NOT fill above the 2L fill line. Close the fill port cover.

3

Using a Preset Function

Tap the button for your desired preset (SPIKED SLUSH, SLUSH etc.). The preset temperature will flash on the screen and then show the current temperature whilst cooling.

4

Adjusting and Saving a Preset

Tap the + or - buttons to manually adjust to your desire temperature. Once the unit has chilled down to this temperature and you have confirmed this is the consistancy you wish to save, press and the appropriate preset button for 3 seconds, until the function light flashes. Your new preset temperature is now saved.

5

Dispensing

Simply operate the handle with a glass uned the nozzle to exact your slushy from the machine. Never tip or tilt the machine from being upright.

Cleaning & Maintenance

To prevent illness and disease it is recommended to complete the cleaning and maintenance work after each use of the machine.

1

Rinsing

1. Add 35-45°c water to the tank via the fill port, fill to the 2L fill mark.

2. Press and hold the Rinse button for 3 seconds to start the rinse cycle.

3. Allow to run until clean, empty the drop via the nozzle.

4. Repeat if neccesary.

2

Removing Parts for Maintenance & Deep Clean

1. Power Off: Turn off the power switch and unplug the unit.

2. Disassembly: Disassemble the unit by following the installation steps in reverse.

3. Sealing Ring: Gently pull out the sealing ring to remove it. Be careful not to stretch it excessively. Soak in nuetral detergent for 5 minutes and rinse thoroughly with water. Inspect frequently and replace immediately in the event of damage to the seal.

4. Evaporator: Caution: Do not use hard objects to scrape the surface of the evaporator. Use a soft brush for stubborn stains.

5. Main Body: Wipe the body with a soft, slightly damp cloth. Do not use chemical cleaners or solvents. KEEP machine upright when cleaning.

6. Tanks: Rinse with running water for 30 seconds per piece, use a soft brush for stubborn stains. Dishwasher safe.

7. Drip Tray: Empty the drip tray, rinse it with a mild/neutral detergent, and dry it thoroughly.

8. Drying: Allow to airdry. Ensure all parts are completely dry before assembly.